Re: XPL question

[Harry Binswanger hb@xxxxxxxx]

Note: S/G 588 (below) is carriage-return+line-feed. It's the VA$M+6 that
I'm concerned about.
> I have at the bottom of a program a place to exit to when errors occur. It
> saves various info on the program state to a file, ERRORS. I'd like it to
> show memory usage at the time the error occurred. I'm not sure if what I
> have now does that, or if it only shows the memory after the program has
> exited:
>
> XPLeNCODE v2.0
> b-gin [UNTITLED]
> {<}LBH{>};*; PROC.ERR [cr|lf][BC_][BX_]ne/nv errors[Q2_];*;[c
> r|lf][TF_]{<}VA$FI{>} error message (if any): {<}PV09{>}{<}PV
> 588{>}{<}PV588{>}err.no = {<}PV101{>}{<}PV588{>}{<}PV588{>}Po
> st.number = {<}PV12{>}{<}PV588{>}{<}PV588{>}Last.post = Memor
> y usage = {<}VA$M+6{>}{<}PV588{>}{<}EX1{>};*;[cr|lf]
> -nd
> XPLeNCODE
>
> Is this what I want?
>
> Thanks,
> Harry
>
> Harry Binswanger
> hb@xxxxxxxx


Harry Binswanger
hb@xxxxxxxx