[Date Prev][Date Next][Subject Prev][Subject Next][
Date Index][
Subject Index]
Stack installation problems
- Subject: Stack installation problems
- From: Fenda Filmes fenda@xxxxxxxx
- Date: Sun, 10 Jan 1999 22:55:36 +0100
My installation of STACK was not sucessful. I'll comment it step by step
to get the error.
Step 1. I disregarded the installation of REORGANIZE because the Jumbo
library is already installed in my XyWrite system.
Step 2. I located STACK.DLG in my XyWrite directory.
Step 3. I called my existing DLG file into a window and then I merged
STACK.DLG into this file at the top. I saved the file via
LOADHELP. I also tested with STACK.DLG merged in the middle of
my XY4.DLG file.
Step 4. I called STARTUP.INT and I copied below the "LOGIN" command:
JM stack.intQ2 ;*;
I tested several positions for this line: always after the .DLG and
before or after the JUMBO file.
Step 5. I put the following changes in my .KBD file:
Change my BC key to: 63=XH,BC,$S
Change my XC key to: 67=XH,$S,XC
Change my Enter key to: 28=XH,$E
I maked a "Hint" key: 21=XH,GH,DX,EL,SI,¥,H,$S (in my
TABLE=CTRL)
Step 6. I reload XyWrite and no sucess. I always receive the same
message: "SX command requires a number: ".
Remarks:
-- If I issue (on the command line) "Help XyWrite", etc., no
response. I'm not installed.
-- I uninstalled STACK and I tested S/G between 619 and 643. No problem.
They are free.
-- I am running XyWrite 4.014.
Any suggestion would be welcome. Thank you very much.
Manuel Castelao