Re: vDosPlus XyWrite 3.00 – first build based on the current Autumn '16 branch

[Kari Eveli lexitec@xxxxxxxx]

Jordan,

Thank you for using the installer. If there are no major technical
reasons to keep updating the Winter '15 branch (I have not seen any so
far), the version 2.01 will be the last one that sports the Winter '15
vDosPlus.exe. Beginning from version 3.00 only Autumn '16 vDosPlus.exe
will be used in the installers. You can, of course, manually install
another version of another branch (depending on the availability of such
versions) on top of the installation. This may entail minor
incompatibilities with the documentation (manual.txt, config.txt, etc.),
so you have to copy Wengier's readme.txt and refer to it for details and
fix things manually in config.txt.


Latest downloadable installers:
http://www.lexitec.fi/xywrite/vDosPlus300_Setup.zip (Autumn '16)
http://www.lexitec.fi/xywrite/vDosPlus201_Setup.zip (Winter '15)

Best regards,

Kari Eveli
LEXITEC Book Publishing (Finland)
lexitec@xxxxxxxx

*** Lexitec Online ***
Lexitec in English: http://www.lexitec.fi/english.html
Home page in Finnish: http://www.lexitec.fi/


11.10.2016, 18:41, J R FOX kirjoitti:
> Thanks very much, Kari.
>
> So, both branches are receiving a similar installer treatment ? (From
> you ?)
>
> I installed the last one (15 branch, I believe -- it was 2.0) on an
> office desktop, and the procedure went smoothly, so you've clearly done
> a good job with the installer, I'd say. That should not be minimized,
> as it's hard to anticipate everything at the user end, and I'm sure
> there must have been plenty of things that could go wrong with it. I
> have not had a chance to try out any printing yet. This is our
> "satellite" office, and I won't be back there until the end of the
> week. We have an HP laser and a wireless HP Deskjet there.
>
>
>
>   Jordan