Thanks, Kari, I'll pick up those files right now. Setting up from the disk images required a small trick or two on my Linux system, but it all went well. Of course I am pretty used to Xy4 and this is a bit different, but not enough so to present anything more than short-term issues. Still that raises the question ... which product is preferrable, 3+ or 4? (I realize the answer is "it depends" but is there any general sentiment?) Mahalo, On Sun, Jul 10, 2022 at 11:18 PM Kari Eveli <lexitec@xxxxxxxxxxx> wrote: > > Bob, > > When you set up Xy3+, there are new optimized PCL printer files for it > at: https://www.lexitec.fi/xywrite/PCL_print_files_for_XY3.zip > > These support directly CP437 and HP 10U symbol set instead of the twists > of earlier print files. The PT numbering implemented is easy to use. > > Best regards, > > Kari Eveli > LEXITEC Book Publishing (Finland) > lexitec@xxxxxxxxxx > > *** Lexitec Online *** > Lexitec in English: https://www.lexitec.fi/english.html > Lexitec English and Finnish dictionaries: https://sk.lexitec.fi/en/ > Home page in Finnish: https://www.lexitec.fi/ > > Bob Newell wrote: > > Thank you for this. I started with Xy2 and it's not so thrilling, and > > then leaped to Xy4, which of course is super but have always heard > > such good things about Xy3+ and never could get hold of it. I'll see > > about getting this set up now! > -- Bob Newell Honolulu, Hawai`i Via Linux/Emacs/Gnus/BBDB.